5 DIY Tips On Fixing A Cabinet Cooler

So your cabinet cooler doesn’t work well anymore. You need to get it fixed but for one reason or the other, you do not want to call a technician to fix it. Maybe you want to save the money or you like the idea of fixing it by yourself. It would be nice if you could fix the cabinet cooler by yourself and keep your electronics protected. Not to worry, there are five do it yourself tips that have been compiled below to help you fix your cabinet cooler.

1. Unplug

The first thing that you want to do is to unplug the cabinet cooler. It is very dangerous to work on it when it’s still plugged and you want to put it down in a place where you can carefully and comfortably work on it. You should probably work on it outdoors as opposed to indoors. One good place to work on it is the garage. Just ensure you unplug it and take it off the wall.

2. Take out the grille

It is not possible to have access to the inner parts of the cabinet cooler if the grille is still on. Take out the filter as well. After than take the screws off so that you can lift off the metal casing that holds it. Be very careful not to cause any further damage.

3. The filter

Proceed to properly clean the filters or replace them with some new ones. You can purchase a new filter anywhere if you specify the kind of cabinet cooler that you have. These filters are found in appliance shops that you can easily access. The filter is a very important component of the cabinet cooler. Without a good filter, the cabinet cooler cannot be as effective as it should be in performing its functions.

4. Cleaning

When a cabinet cooler stops functioning well, it is possible that it just needs to be cleaned. The coils as well as the fins need to be cleaned. Remember, a cabinet cooler is not a fan. Sure, they serve almost the same purpose but the cabinet cooler is more intense and its parts need to be cleaned properly for it to work well. If you have a rag that you can use for cleaning, make sure you use it. Clean all the parts and let them dry well before you assemble them again.

5. Lubrication

You would have to use your user manual to be able to do this properly. Since you already have the parts disassembled, it would be a perfect time to lubricate the coils, screws and all other bearings. This will ensure there is minimal resistance to movement.



Leave a Reply